DTC Diagnosis Procedure

CONSULT

1. Ignition switch ON.
2. Select erase "Self Diagnostic Results" mode.
3. Ignition switch OFF and wait for at least 10 seconds.
4. Start the engine.
   CAUTION: Never drive the vehicle.
5. Select "Self Diagnostic Result" mode of "EPS/DAST 3".

Is DTC "C1608-46" detected?

YES

EPS control unit is malfunctioning. Replace steering gear assembly. Refer to Removal and Installation .

NO

Check pin terminal and connection of each harness connector for malfunctioning conditions.