Work Procedure: Description

WARNING: This page is about a different car, the 2020 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.

Since vehicle specifications are not included in the ADAS control unit after replacement, it is required to write vehicle specifications with CONSULT.

Configuration has three functions as follows.

Function		Description
Read/Write Configuration	Before Replace ECU	Allows the reading of vehicle specification written in ADAS control unit to store the specification in CONSULT.
	After Replace ECU	Allows the writing of the vehicle information stored in CONSULT into the ADAS control unit.
Manual Configuration		Allows the writing of the vehicle specification into the ADAS control unit by hand.

CAUTION:

Use "Manual Configuration" only when "Parts number" of ADAS control unit cannot be read.
If an error occurs during configuration, start over from the beginning.

CHECKING PARTS NUMBER
CONSULT
1. Select "Before Replace ECU" of "Read/Write Configuration".
2. Check that "Parts number" is displayed on CONSULT.
Is "Parts number" displayed?

YES

GO TO 2.

NO

GO TO 6.
VERIFYING PARTS NUMBER (1)
CONSULT

Compare "Parts number" displayed on the CONSULT screen with the one searched for using FAST (service parts catalogue) to check that these "Parts number" agree with each other.

NOTE: For the "Parts number" searched for using FAST (service parts catalog), use the last five digits of the "Parts number".

GO TO 3.
SAVING PARTS NUMBER
CONSULT

Save "Parts number" on CONSULT.

GO TO 4.
REPLACE ADAS CONTROL UNIT (1)
Replace ADAS control unit. Refer to ADAS CONTROL UNIT : Removal & Installation (Without ProPILOT Assist) or ADAS CONTROL UNIT : Removal & Installation (With ProPILOT Assist).

GO TO 5.
WRITING (AUTOMATIC WRITING)
CONSULT
1. Select "After Replace ECU" of "Re/programming, Configuration" or that of "Read / Write Configuration".
2. Select the "Parts number" agreeing with the one stored on CONSULT and the one searched for using FAST (service parts catalogue) to write the "Parts number" into the ADAS control unit.
GO TO 8.
REPLACE ADAS CONTROL UNIT (2)
Replace ADAS control unit. Refer to ADAS CONTROL UNIT : Removal & Installation (Without ProPILOT Assist) or ADAS CONTROL UNIT : Removal & Installation (With ProPILOT Assist).

GO TO 7.
WRITING (MANUAL WRITING)
CONSULT
1. Select "Manual Configuration".
2. Select the "Parts number" searched for using FAST (service parts catalogue) to write the "Parts number" into the ADAS control unit.
  NOTE: For the "Parts number" searched for using FAST (service parts catalog), use the last five digits of the "Parts number".
GO TO 8.
VERIFYING PARTS NUMBER (2)
CONSULT

Compare a "Parts number" displayed on the CONSULT screen with the one searched by using FAST (service parts catalogue) to check that these "Parts number" agree with each other.

NOTE: For the "Parts number" searched for using FAST (service parts catalog), use the last five digits of the "Parts number".

GO TO 9.
OPERATION CHECK
Confirm that each function controlled by ADAS control unit operates normally.

Work End.