Work Procedure
WARNING: This page is about a different car, the 2020 Infiniti QX50. However, it is still accessible from the selected car via links, so may be relevant.
- WRITING MODE SELECTION
CONSULT
Select "Reprogramming, Configuration" of sonar control unit.
When writing saved data
GO TO 2.
When writing manually
GO TO 3.
- PERFORM "SAVED DATA LIST"
Automatically "Operation Log Selection" window will display if "Before Replace ECU" was performed. Select applicable file from the "Save Data List" and press "Confirm".
Work End.
- PERFORM "AFTER REPLACE ECU" OR "MANUAL CONFIGURATION"
- Select "After Replace ECU" or "Manual Configuration".
- Identify the correct model and configuration list. Refer to Configuration List .
- Confirm and/or change setting value for each item.CAUTION: Thoroughly read and understand the vehicle specification. ECU control may not operate normally if the setting is not correct.
- Select "Next".CAUTION: Make sure to select "Next", confirm each setting value and press "OK" even if the indicated configuration of brand new sonar control unit is same as the desirable configuration. If not, configuration which is set automatically by selecting vehicle model can not be memorized.
- When "Completed", select "End".
GO TO 4.
- OPERATION CHECK
Confirm that each function controlled by sonar control unit operates normally.
Work End.