DTC Confirmation Procedure
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always place the ignition switch in the OFF position and wait at least 10 seconds before conducting the next test.
GO TO 2.
- DTC REPRODUCTION PROCEDURE
CONSULT
- Start the engine.CAUTION: Never drive the vehicle.
- Select "Self Diagnostic Result" mode of "EPS/DAST 3".
Is DTC "C1607" detected?
YES
Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure .
NO
To check malfunction symptom before repair, refer to Inspection .
NO
Confirmation after repair: Inspection End.
- Start the engine.