Work Procedure
WARNING: This page is about a different car, the 2020 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
- PROGRAM THE ABS ACTUATOR AND ELECTRIC UNIT
CONSULT
Perform configuration of the ABS actuator and electric unit. Refer to Work Procedure .
NOTE: If this is a new/blank module, the ABS Actuator and Electric Unit will need to be programmed prior to configuration.GO TO 2.
- ADJUST NEUTRAL POSITION OF THE STEERING ANGLE SENSOR
Perform adjustment of the neutral position of steering angle sensor. Refer to Work Procedure .
GO TO 3.
- CALIBRATION OF DECEL G SENSOR
Perform calibration of decel G sensor. Refer to Work Procedure .
Inspection End.