Work Procedure

WARNING: This page is about a different car, the 2020 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.

Vehicle specification needs to be written with CONSULT because it is not written after replacing sonar control unit.

Configuration has three functions as follows:

Function	Description
"Before Replace ECU"	Reads the vehicle configuration of current sonar control unit. Saves the read vehicle configuration.
"After Replace ECU"	Writes the vehicle configuration with manual selection.
"Select Saved Data List"	Writes the vehicle configuration with saved data.

CAUTION:

When replacing sonar control unit, you must perform "Select Saved Data List" or "After Replace ECU" with CONSULT.
Complete the procedure of "Select Saved Data List" or "After Replace ECU" in order.
If you set incorrect "Select Saved Data List" or "After Replace ECU", incidents might occur.
Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
Never perform "Select Saved Data List" or "After Replace ECU" except for new sonar control unit.

WRITING MODE SELECTION
CONSULT

Select "Reprogramming, Configuration" of sonar control unit.

When writing saved data

GO TO 2.

When writing manually

GO TO 3.
PERFORM "SAVED DATA LIST"
CONSULT

Automatically "Operation Log Selection" window will display if "Before Replace ECU" was performed. Select applicable file from the "Save Data List" and press "Confirm".

Work End.
PERFORM "AFTER REPLACE ECU" OR "MANUAL CONFIGURATION"
CONSULT
1. Select "After Replace ECU" or "Manual Configuration".
2. Identify the correct model and configuration list. Refer to Work Item List .
3. Confirm and/or change setting value for each item.
  CAUTION: Thoroughly read and understand the vehicle specification. ECU control may not operate normally if the setting is not correct.
4. Select "Next".
  CAUTION: Make sure to select "Next", confirm each setting value and press "OK" even if the indicated configuration of brand new sonar control unit is same as the desirable configuration. If not, configuration which is set automatically by selecting vehicle model can not be memorized.
5. When "Completed", select "End".
GO TO 4.
OPERATION CHECK
Confirm that each function controlled by sonar control unit operates normally.

Work End.