Detailed Flow
- INTERVIEW FROM THE CUSTOMER
Clarify customer complaints before inspection. First of all, perform an interview utilizing Diagnostic Work Sheet and reproduce the symptom as well as fully understand it. Ask customer about his/her complaints carefully. Check symptoms by driving vehicle with customer, if necessary.
CAUTION: Customers are not professional. Never guess easily like "maybe the customer means that...," or "maybe the customer mentions this symptom".GO TO 2.
- CHECK SYMPTOM
Reproduce the symptom that is indicated by the customer, based on the information from the customer obtained by the interview. Also check that the symptom is not caused by fail-safe mode. Refer to Fail-safe .
CAUTION: When the symptom is caused by normal operation, fully inspect each portion and obtain the understanding of customer that the symptom is not caused by a malfunction.GO TO 3.
- PERFORM SELF-DIAGNOSIS
With CONSULT
Perform self-diagnosis for "CHASSIS CONTROL".
Is DTC detected?
YES
Record or print "Self Diagnostic Result" and freeze frame data (FFD). GO TO 4.
NO
INSPECTION END
- PERFORM DTC DIAGNOSIS PROCEDURE
Perform confirmation procedures for the malfunctioning system.
NOTE: If some DTCs are detected at the same time, determine the order for performing the diagnosis based on DTC Inspection Priority Chart .Is DTC detected?
YES
GO TO 5.
NO
Check harness and connectors based on the information obtained by the interview.
- REPAIR OR REPLACE MALFUNCTIONING PARTS
- Repair or replace malfunctioning parts.
- Reconnect part or connector after repairing or replacing.
- When DTC is detected, erase "Self Diagnostic Result" of "CHASSIS CONTROL".
GO TO 6.
- FINAL CHECK
- Check the reference value of "CHASSIS CONTROL".
- Recheck the symptom and check that the symptom is not reproduced on the same conditions.
Is the symptom reproduced?
YES
GO TO 3.
NO
INSPECTION END