Active Test
The active test is used to determine and identify details of a malfunction, based on self-diagnosis test results and data obtained in the DATA MONITOR. In response to instructions from CONSULT, instead of those from chassis control module (with built in steering angle sensor) on the vehicle, a drive signal is sent to the actuator to check its operation.
- Never perform ACTIVE TEST while driving the vehicle.
- Always bleed air from brake system before active test.
- Never perform active test when system is malfunctioning.
- When active test is performed while depressing the brake pedal, the brake pedal depressing stroke may change. This is not a malfunction.
- During an active test, sometimes a chassis control warning is displayed and the master warning lamp illuminates on the information display in the combination meter; however, this is not a malfunction.
|
Test item |
Operation |
Description |
|
BRAKE ACTUATOR 1 MODE 1 |
Start |
Controls brake fluid pressure. |
|
BRAKE ACTUATOR 1 MODE 2 |
Start |
Controls brake fluid pressure. |
|
BRAKE ACTUATOR 1 MODE 3 |
Start |
Controls brake fluid pressure. |
|
BRAKE ACTUATOR 2 MODE 1 |
Start |
Controls brake fluid pressure. |
|
BRAKE ACTUATOR 2 MODE 2 |
Start |
Controls brake fluid pressure. |
|
BRAKE ACTUATOR 2 MODE 3 |
Start |
Controls brake fluid pressure. |
|
BRAKE ACTUATOR 3 MODE 1 |
Start |
Controls brake fluid pressure. |
|
BRAKE ACTUATOR 3 MODE 2 |
Start |
Controls brake fluid pressure. |
|
BRAKE ACTUATOR 3 MODE 3 |
Start |
Controls brake fluid pressure. |
|
MASTER WARNING ACTIVE |
On |
If touching "On" with the master warning lamp not illuminated, the master warning lamp illuminates. Stops in approximately 1 minute. |
|
Off |
The master warning lamp turns OFF. (vehicle in normal state) |
|
|
Automatic brake hold lamp active |
Standby (white) lamp lighting |
Turn On the automatic brake hold indicator lamp (white) in the combination meter. |
|
Operation (green) lamp lighting |
Turn On the automatic brake hold indicator lamp (green) in the combination meter. |
|
|
Automatic brake hold SW lamp active |
LED lighting |
Turn On the automatic brake hold switch indicator. |
|
LED blinking (1Hz) |
Blink the automatic brake hold switch indicator. |