April 5, 2026: LEMON Manuals is launched! Read the announcement.

Wake-Up Operation

BCM transmits the sleep wake-up signal (wake up) to each unit when any of the CAN wake-up conditions are fulfilled. It changes from the low power consumption mode or the CAN communication sleep mode to the normal mode.
Each unit starts the transmission of CAN communication with the sleep wake-up signal. In addition, the combination meter transmits the wake-up signal to BCM via CAN communication to report the CAN communication start.

BCM wake-up condition

CAN wake-up condition

Door lock switch: OFF → ON
Door unlock switch: OFF → ON
Back door switch assembly (opener switch): OFF → ON

Receiving the sleep-ready signal (Not-ready) from any units
Hazard switch: OFF → ON, ON → OFF
PASSING LAMP switch: OFF → ON, ON → OFF
TAIL LAMP switch: OFF → ON, ON → OFF
Front door switch LH: OFF → ON, ON → OFF
Front door switch RH: OFF → ON, ON → OFF
Back door lock assembly (ajar switch): OFF → ON, ON → OFF
Stop lamp switch signal: ON
Low beam switch: OFF → ON, ON → OFF
High beam switch: OFF → ON, ON → OFF
Push-button ignition switch: OFF → ON
Key switch: OFF → ON, ON → OFF
Rear door switch LH, RH: OFF → ON, ON → OFF
FR FOG switch: OFF → ON, ON → OFF