Data Monitor
|
Item [Unit] |
Description |
|
|
IGN VOLT |
[V] |
Displays the power switch ON power supply voltage. |
|
CONTROL MODULE MALF |
[Off / On] |
Displays the chassis control module malfunction. |
|
CAN DIAG STATUS |
[Off / On] |
Displays CAN network diagnosis status. |
|
STP LAMP OFF RELAY 1 |
[Off / On] |
Displays stop lamp OFF relay 1 status. |
|
STP LAMP OFF RELAY 2 |
[Off / On] |
Displays stop lamp OFF relay 2 status. |
|
Stop lamp ON relay drive status |
[Off / On] |
Displays stop lamp ON relay status. |
|
VEHICLE SPEED |
[km/h] |
Displays the vehicle speed. |
|
FR WHEEL SPEED |
[RPM] |
Displays the rotational speed of front RH tire. |
|
FL WHEEL SPEED |
[RPM] |
Displays the rotational speed of front LH tire. |
|
RR WHEEL SPEED |
[RPM] |
Displays the rotational speed of rear RH tire. |
|
RL WHEEL SPEED |
[RPM] |
Displays the rotational speed of rear LH tire. |
|
STEERING ANG SENSOR |
[deg] |
Displays the steering angle from the steering angle sensor. |
|
DECEL G SENSOR |
[G] |
Displays the decel G. |
|
SIDE G SENSOR |
[G] |
Displays the side G. |
|
YAW RATE SENSOR |
[deg/s] |
Displays the yaw rate. |
|
ACCELE PEDAL POSITION |
[%] |
Displays the accelerator pedal position. |
|
THROTTLE CONTROL |
-- |
Displays but not used. |
|
SHIFT POSITION |
-- |
Displays but not used. |
|
BRAKE SWITCH 2 |
[Off / On] |
Displays the brake pedal operating status. |
|
BRAKE SWITCH 1 |
[Off / On] |
Displays the brake pedal operating status. |
|
Stop lamp switch |
[ACT / INACT] |
Displays the stop lamp switch status. |
|
STOP LAMP SW |
[ACT / INACT] |
Displays the stop lamp switch status. |
|
PRESS SENSOR |
[bar] |
Displays the brake fluid pressure. |
|
ABS |
[NORMAL / ABNOR] |
Displays the ABS function status. |
|
ABS MALF |
[NORMAL / ABNOR] |
Displays the ABS function status. |
|
EBD |
[NORMAL / ABNOR] |
Displays the EBD function status. |
|
TCS |
[NORMAL / ABNOR] |
Displays the TCS function status. |
|
TCS MALF |
[NORMAL / ABNOR] |
Displays the TCS function status. |
|
VDC |
[NORMAL / ABNOR] |
Displays the VDC function status. |
|
VDC MALF |
[NORMAL / ABNOR] |
Displays the VDC function status. |
|
VDC OFF SWITCH |
[Off / On] |
Displays VDC OFF status. |
|
PARKING BRAKE |
[Off / On] |
Displays parking brake status. |
|
DRV TRQ CTRL MODE |
[INITIAL / NORMAL / STOP 1 / STOP 2 / LIMIT 1 / PROHIBI] |
Displays the status of correction to slightly increase/decrease the drive torque. |
|
DRV TRQ CTRL PERMIS 1 |
[NO PER / PERMIS] |
Displays the permission status (basic requirement) of correction to slightly increase/decrease drive torque. |
|
DRV TRQ CTRL PERMIS 2 |
[NO PER / PERMIS] |
Displays the permission status (system requirement) of correction to slightly increase/decrease drive torque. |
|
DRV TRQ CTRL STOP |
[REQ / NO REQ] |
Displays the stop request status of correction to slightly increase decrease drive torque. |
|
DRV TRQ CTRL PROHIBIT |
[REQ / NO REQ] |
Displays the prohibition request status of correction to slightly increase/ decrease drive torque. |
|
ATC 1 |
[Off / On] |
Displays the intelligent trace control function operation status. |
|
ATC 2 |
[Off / On] |
Displays the intelligent trace control function operation status. |
|
ATC 4 |
[Off / On] |
Displays the intelligent trace control function operation status. |
|
ATC 3 |
[Off / On] |
Displays the intelligent trace control function operation status. |
|
FL TIRE DISP |
[DEF / 1] |
Displays the status of front LH tire displayed on the information display in the combination meter. |
|
FR TIRE DISP |
[DEF / 1] |
Displays the status of front RH tire displayed on the information display in the combination meter. |
|
RL TIRE DISP |
[DEF / 1] |
Displays the status of rear LH tire displayed on the information display in the combination meter. |
|
RR TIRE DISP |
[DEF / 1] |
Displays the status of rear RH tire displayed on the information display in the combination meter. |
|
INTERRUPT DISP |
-- |
Displays but not used. |
|
TURN DISP |
[N STEER / LEFT / RIGHT] |
Displays the turning direction of intelligent trace control function on the information display in the combination meter. |
|
ATC DISP |
[Off / On] |
Displays the operating status of intelligent trace control function displayed on the information display in the combination meter. |
|
AEB |
-- |
Displays but not used. |
|
ATC 5 |
[Off / On] |
Displays the intelligent trace control function operation status. |
|
ATC SETTING |
[Off / On] |
Displays the setting status of intelligent trace control function by steering switch. |
|
Buckle SW |
Off / On |
Displays the seat belt buckle switch (driver side) status. |
|
VDC (ABH active) |
Possible / Impossible |
Displays the e-Pedal active status at ABS actuator and electric unit (control unit). |
|
ABH (CCM) |
Off / On |
Displays the brake hold status at e-Pedal. |
|
Slope |
Slow / Steep |
Displays the slope status. |
|
PB active request (VDC) |
-- |
Displays but not used. |
|
CCM (VDC) |
Normal / Abnormal |
Displays the chassis control module status detected by ABS actuator and electric unit (control unit). |
|
PB active request (CCM) |
-- |
Displays but not used. |
|
PB SW |
Off / Release |
Displayed the parking brake switch status. |
|
ABH active request (CCM) |
REQ / NO REQ |
Displays the e-Pedal request status to electrically-driven intelligent brake unit from chassis control module. |
|
ABH malfunction |
Normal / Abnormal |
Displays the e-Pedal status. |
|
ABH indicator lamp |
-- |
Displays but not used. |
|
ABH active request (ADAS) 1 |
-- |
Displays but not used. |
|
PB |
-- |
Displays but not used. |
|
CCM (PB) |
-- |
Displays but not used. |
|
PB (ABH active) |
-- |
Displays but not used. |
|
PB malfunction status |
-- |
Displays but not used. |
|
ABH active request (ADAS) 2 |
-- |
Displays but not used. |
|
ABH active request (ADAS) 3 |
-- |
Displays but not used. |
|
ADAS |
NO REQ / REQ |
Displays the ADAS control unit status. |
|
ABH (ADAS) |
Inactive / ACTIVE |
Displays the brake stop hold request status from ADAS control unit. |
|
ABH SW |
-- |
Displays but not used. |
|
ABH SW indicator lamp |
-- |
Displays but not used. |
|
ABH active judge (CCM) |
OK / NG |
Displays the judgement of e-Pedal active states. |
|
e-Pedal status 1 |
NORMAL / MALF |
Displays e-Pedal status. |
|
e-Pedal estimated slope permission |
Not permission / Permission |
Displays slope estimated status. |
|
e-Pedal smooth stop permission |
Not permission / Permission |
Displays smooth stop status. |
|
Slope assist torque |
Nm |
Displays slope assist torque. |
|
Brake force limit torque |
Nm |
Displays brake force limit torque. |
|
Electric parking brake active request |
-- |
Displays but not used. |
|
e-Pedal stop hold request |
NO REQ / REQ |
Displays the brake hold request status to electrically-driven intelligent brake unit from chassis control module. |
|
e-Pedal status 2 |
NORMAL / MALF |
Displays e-Pedal status. |
|
e-Pedal brake active request |
NO REQ / REQ |
Displays brake operation request status. |
|
e-Pedal SW indicator lamp 1 |
-- |
Displays but not used. |
|
e-Pedal SW indicator lamp 2 |
-- |
Displays but not used. |
|
ProPILOT status information |
Inactive / Active |
Displays ProPILOT status. |
|
e-Pedal stop hold request torque |
Nm |
Displays e-Pedal stop hold torque request. |
|
Brake operation request display |
NORMAL / MALF |
Displays brake operation request status. |
|
e-Pedal VCM status |
NORMAL / MALF |
Displays e-Pedal status from VCM. |
|
e-Pedal switch |
Off / On |
Displays e-Pedal switch status. |
|
Electric parking brake active status (driving) |
-- |
Displays but not used. |
|
Mechanical parking brake status |
Release / Apply |
Displays parking brake status. |
|
ProPILOT active status |
Inactive / Active |
Displays ProPILOT status. |
|
Driver brake operation |
Off / On |
Displays brake pedal status. |
|
Driver request torque |
Nm |
Displays braking torque when releasing the accelerator pedal. |
|
Slope resistance estimate |
Nm |
Displays braking torque estimated from the driving torque and the driving motor speed. |
|
Traction motor speed |
RPM |
Display motor speed. |
|
Coast status |
Normal / Decrease / Increase |
Display braking torque limit to the VCM from ABS actuator and electric unit (control unit). |
|
Chassis dynamometer mode |
Off / On / Not used |
Displays mode status of the chassis dynamometer. |
|
e-Pedal hold status |
Release / Hold / Decrease / Increase |
Display vehicle stop status by e-Pedal. |
|
e-Pedal brake request torque |
Nm |
Display request braking force from VCM to electrically-driven intelligent brake unit. |