Wake-up operation

BCM transmits sleep wake up signal (wake up) to each unit when any condition listed below is established, and then goes into normal mode from low power consumption mode.
Each unit starts transmissions with CAN communication by receiving sleep wake up signals. Each unit transmit wake up signals to BCM with CAN communication to convey the start of CAN communication.

Wake-up condition

Receiving the sleep-ready signal (Not-ready) from any units
Power switch (push switch): OFF-> ON
Hazard switch: ON
HI BEAM switch: OFF -> ON, ON -> OFF
PASSING switch: OFF -> ON, ON -> OFF
HEADLAMP 1 switch: OFF -> ON, ON -> OFF
HEADLAMP 2 switch: OFF -> ON, ON -> OFF
TAIL LAMP switch: OFF -> ON
FR FOG switch: OFF -> ON, ON -> OFF
TURN RH: OFF -> ON, ON -> OFF
TURN LH: OFF -> ON, ON -> OFF
Front door switch LH: OFF -> ON, ON -> OFF
Front door switch RH: OFF -> ON, ON -> OFF
Rear door switch RH: OFF -> ON, ON -> OFF
Rear door switch LH: OFF -> ON, ON -> OFF
Back door lock assembly (door switch): OFF -> ON, ON -> OFF
Front outside handle LH (request switch): OFF -> ON
Front outside handle RH (request switch): OFF -> ON
Back door opener assembly (request switch): OFF -> ON
Back door opener assembly (opener switch): OFF -> ON
Stop lamp switch: ON
Door lock and unlock switch: NEUTRAL -> LOCK, NEUTRAL -> UNLOCK
Front door lock assembly LH (door key cylinder switch): NEUTRAL -> LOCK, NEUTRAL -> UNLOCK
Remote keyless entry receiver communication: Receiving
Front door lock assembly LH (unlock sensor): OFF -> ON, ON -> OFF