Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.

GO TO 2.

If DTC P2015 is displayed with DTC P0643, first perform the trouble diagnosis for DTC 0643

Is applicable DTC detected?

YES

Refer to DTC Description .

NO

GO TO 3

1. Turn ignition switch ON.
2. Warm up the engine to the normal operating temperature and keep the engine speed at idle for 10 seconds.
   NOTE: Warm up the engine until "COOLAN TEMP/S" on "DATA MONITOR" of CONSULT reaches at least 60 deg. C (140 deg. F).
3. Keep the engine speed 5, 000 RPM for at least 10 seconds under no load.
4. Check 1st trip DTC.

Is 1st trip DTC detected?

YES

Refer to DTC Diagnosis Procedure .

NO

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO

Confirmation after repair: INSPECTION END