Calibration Of DECEL G Sensor

CAUTION: To calibrate the decel G sensor, make sure to use CONSULT.

(Calibration cannot be done without CONSULT).

ALIGN THE VEHICLE STATUS
Stop vehicle with front wheels in straight-ahead position.

GO TO 2.
PERFORM CALIBRATION OF DECEL G SENSOR
CONSULT
1. Select "Work support" and "DECEL G SEN CALIBRATION" in order.
2. Select "Start".
3. After approximately 10 seconds, select "End".
  NOTE: After approximately 60 seconds, it ends automatically.
4. Ignition switch OFF -> ON.
  CAUTION: Be sure to perform above operation.
GO TO 3.
CHECK DATA MONITOR
CONSULT
1. Run vehicle with front wheels in straight-ahead position, then stop.
2. Select "Data Monitor" mode of "ABS". Then make sure "DECEL G-SEN" is within +/- 0.05 G.
Is the inspection result normal?

YES

GO TO 4.

NO

Perform calibration of decel G sensor again, GO TO 1.
ERASE THE SELF DIAGNOSTIC RESULT MEMORY
CONSULT

Erase the "Self Diagnostic Result" memory of the ABS actuator and electric unit (control unit) and ECM.
- ABS actuator and electric unit (control unit): Refer to CONSULT Function (ABS) .
- ECM: Refer to CONSULT Function .
Are the memories erased?

YES

Inspection End.

NO

Check the items indicated by the self-diagnosis.