LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2021 >> Versa S, Standard Trans >> Repair and Diagnosis >> Steering >> Steering Column >> Steering System >> Unit Disassembly And Assembly >> Steering Gear And Linkage >> Disassembly and Assembly >> Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Disassembly and Assembly: Assembly

  1. Install hole cover (1), aligning arrow (A) to mark (B) on steering gear housing (2).
    GNSALGIA0318Z-318Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not reuse hole cover.
  2. Install large end of boot (1) to steering gear housing.
    GNSALGIA0327Z-327Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not reuse boot.
  3. Apply silicone grease between inner socket and small end of boot.
  4. Install small end of boot (2) to inner socket boot mounting groove.
    CAUTION: To prevent boot deformation or damage during toe-in adjustment, apply silicone grease between inner socket and small end of boot.
  5. Install small boot clamp (B).
    GNSAWGIA0460Z-460Courtesy of NISSAN NORTH AMERICA, INC.
  6. Install large boot clamp (A) using suitable tool.
    CAUTION: Do not reuse boot clamps.
  7. Install inner socket lock nut and outer socket.
  8. Adjust inner socket (1) to standard length (A), then tighten inner socket lock nut (B) to specification. Refer to Exploded View . Verify inner socket length after tightening lock nut.
    GNSAWGIA0459Z-459Courtesy of NISSAN NORTH AMERICA, INC.

    Inner socket length (A)

    : Refer to Inner Socket Length .
    CAUTION: To prevent damage, hold outer socket across flats using suitable tool while tightening inner socket lock nut.
scientia non olet · About LEMON Manuals