Diagnosis Procedure

1. Ignition switch ON.
2. Check signal between main power window and door lock/unlock switch harness connector and ground with oscilloscope.

   (+)		(-)	Signal (Reference value)
   Main power window and door lock/unlock switch
   Connector	Terminal
   D7	4	Ground	Refer to following signal
   	5

   Courtesy of NISSAN NORTH AMERICA, INC.

Is the inspection result normal?

YES

GO TO 7.

NO

GO TO 2.

1. Ignition switch OFF.
2. Disconnect main power window and door lock/unlock switch connector and front power window motor LH connector.
3. Check continuity between main power window and door lock/unlock switch harness connector and front power window motor LH harness connector.

   Main power window and door lock/unlock switch		Front power window motor LH		Continuity
   Connector	Terminal	Connector	Terminal
   D7	4	D9	6	Yes
   	5		4

4. Check continuity between main power window and door lock/unlock switch harness connector and ground.

   Main power window and door lock/unlock switch		Ground	Continuity
   Connector	Terminal
   D7	4		No
   	5

Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace harness.

1. Connect main power window and door lock/unlock switch connector.
2. Ignition switch ON.
3. Check voltage between front power window motor LH harness connector and ground.

   (+)		(-)	Voltage (Approx.)
   Front power window motor LH
   Connector	Terminal
   D9	5	Ground	Battery voltage

Is the inspection result normal?

YES

GO TO 4.

NO

GO TO 5.

1. Ignition switch OFF.
2. Check continuity between front power window motor LH harness connector and ground.

   Front power window motor LH		Ground	Continuity
   Connector	Terminal
   D9	3		Yes

Is the inspection result normal?

YES

GO TO 7.

NO

GO TO 6.

1. Ignition switch OFF.
2. Disconnect main power window and door lock/unlock switch connector.
3. Check continuity between main power window and door lock/unlock switch harness connector and front power window motor LH harness connector.

   Main power window and door lock/unlock switch		Front power window motor LH		Continuity
   Connector	Terminal	Connector	Terminal
   D7	14	D9	5	Yes

4. Check continuity between main power window and door lock/unlock switch harness connector and ground.

   Main power window and door lock/unlock switch		Ground	Continuity
   Connector	Terminal
   D7	14		No

Is the inspection result normal?

YES

Replace main power window and door lock/unlock switch. Refer to Removal and Installation .

NO

Repair or replace harness.

1. Disconnect main power window and door lock/unlock switch connector.
2. Check continuity between main power window and door lock/unlock switch harness connector and front power window motor LH harness connector.

   Main power window and door lock/unlock switch		Front power window motor LH		Continuity
   Connector	Terminal	Connector	Terminal
   D7	12	D9	3	Yes

Is the inspection result normal?

YES

Replace main power window and door lock/unlock switch. Refer to Removal and Installation .

NO

Repair or replace harness.

Refer to Inspection Procedure.

Inspection End.