Work Procedure

WARNING: This page is about a different car, the 2023 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

SAVING VEHICLE SPECIFICATION
1. CONSULT Enter "Re/Programming, Configuration" and perform "Before Replace ECU" to save or print current vehicle specification.
  NOTE: If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing around view monitor control unit.
>>

GO TO 2.
REPLACE AROUND VIEW MONITOR CONTROL UNIT
1. Replace around view monitor control unit. Refer to Removal and Installation .
>>

GO TO 3.
WRITING VEHICLE SPECIFICATION
1. CONSULT
  1. Enter "Re/Programming, Configuration".
  2. If "Before Replace ECU" operation was performed, automatically an "Operation Log Selection" screen will be displayed. Select the applicable file from the "Saved Data List" and press "Confirm" to write vehicle specification. Refer to Work Procedure .
  3. If "Before Replace ECU" operation was not performed, select "After Replace ECU" or "Manual Configuration" to write vehicle specification. Refer to Work Procedure .
>>

GO TO 4.
OPERATION CHECK
1. Check that the operation of the around view monitor control unit and camera images (fixed guide lines and predictive course lines) are normal.
>>

Work End.