Test 20A - Diagnosing Auto Door Locks
- Using DRB-II, read auto door locks status. If DRB-II does not display AUTO DOOR LOCKS ARE ENABLED, use DRB-II to enable auto door locks and retest system. If DRB-II displays AUTO DOOR LOCKS ARE ENABLED, use DRB-II to actuate auto door locks.
- If doors do not lock, go to TEST 19A. If doors lock, ensure left front door is closed. Read door ajar switch status. If DRB-II does not display LFDOOR AJAR:OPEN, go to TEST 40A.
- If DRB-II displays LFDOOR AJAR:OPEN, ensure right front door is closed. Read door ajar switch status. If DRB-II does not display RFDOOR AJAR:OPEN, go to TEST 41A.
- If DRB-II displays RFDOOR AJAR:OPEN, ensure side door is closed. Read door ajar switch status. If DRB-II does not display SIDE DR AJR:OPEN, go to TEST 42A.
- If DRB-II displays SIDE DR AJR:OPEN, ensure liftgate is closed. Read door ajar switch status. If DRB-II does not display GATE AJAR:OPEN, go to TEST 43A.
- If DRB-II displays GATE AJAR:OPEN, read body controller monitors. If TPS percentage does not increase as throttle is opened, see appropriate G - TESTS W/ CODES article in the ENGINE PERFORMANCE Section to diagnose TPS faults. If TPS percentage increases as throttle is opened, raise and support vehicle.
- Start engine and shift vehicle into Drive (1st gear on manual transmission). Using DRB-II, read body controller monitors. If MPH does not increase as throttle is opened, see appropriate G - TESTS W/ CODES article in the ENGINE PERFORMANCE Section to diagnose VSS faults. If MPH increases as throttle is opened, turn ignition off and retest system. Circuit is okay.