Test 7C - Short To Battery
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagrams, see WIRING DIAGRAMS
article in the ENGINE PERFORMANCE Section.
CAUTION:
Always turn ignition switch to OFF position before disconnecting or connecting any module connector.
- Using DRB-II in voltmeter mode, check voltage at CAB connector terminal No. 41, pedal travel sensor return circuit (Red/Black wire). If voltage is more than 10 volts, repair short to voltage in Red/Black wire and replace CAB module. Perform TEST VER-1.
- If voltage is less than 10 volts, replace CAB module. Perform TEST VER-1.