Test 8E - Short To 5 Volts
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagrams, see WIRING DIAGRAMS
article in the ENGINE PERFORMANCE Section.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
- Using DRB-II in ohmmeter mode, check resistance at MIC or EIC connector ground circuit (Black/Light Green wire).
- If resistance is more than 5 ohms, repair open circuit in Black/Light Green wire. Perform TEST VER-1. If resistance is less than 5 ohms, replace MIC or EIC. Perform TEST VER-1.