Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Position the fender liner to the fender, over the studs and behind the rocker molding.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the nut to the stud at the rear of the front fender liner.
Tighten: Tighten the front fender liner rear nut to 10 N.m (89 lb in).

Fig 1: Identifying Rear Fender Liner Rear Stud Nut
Courtesy of GENERAL MOTORS CORP.
Install the nut to the stud at the front of the front fender liner.
Tighten: Tighten the front fender liner front nut to 10 N.m (89 lb in).

Fig 2: Locating Front Fender Liner Rear Stud Nut
Courtesy of GENERAL MOTORS CORP.
Install the screws to the front fender liner at the front bumper fascia and fender.
Tighten: Tighten the front bumper fascia and fender screws to 2 N.m (18 lb in).

Fig 3: View Of Front Fender Liner Retaining Screws
Courtesy of GENERAL MOTORS CORP.