Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Replacement blade elements (2) have 3 plastic caps (1) which retain the 2 metal flexor strips. Do not remove these caps (1) before the element is installed.

Fig 1: Wiper Blade Element

Courtesy of GENERAL MOTORS CORP.

Important: The heel end of the wiper blade is the end nearest to the base of the wiper arm.

Starting at the heel end of the wiper blade slide the wiper blade element, notched end last, into the wiper blade claw sets (1). The plastic retainer caps will be forced off as the element is fully inserted.

Fig 2: Wiper Blade Claw Sets
Courtesy of GENERAL MOTORS CORP.
Be certain that the 2 element notches are engaged by the last claw set and that all the other claws (2) and (3) and properly engaged in the slots of the element (1) on both sides.
Install the wiper blade onto the wiper arm. Refer to WIPER ARM BLADE REPLACEMENT .

Fig 3: Installing Wiper Blade Onto Wiper Arm
Courtesy of GENERAL MOTORS CORP.