Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Electrical Connector & Sunshade

Courtesy of GENERAL MOTORS CORP.

Route the harness through the mounting bezel.
Insert the mounting bezel into the garnish molding engaging the snap fingers.
Connect the harness to the sunshade electrical connector.
Push the connector up through the bezel and through the hole in the garnish molding.
Position the sunshade approximately midway between the windshield and the side of the vehicle.
Insert the rod with inner bezel firmly attached fully into the mounting bezel.
Rotate the sunshade toward the centerline of the vehicle until the sunshade locks in place.