LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 850 (Cruise Control System) >> Repair Instructions >> Cruise Release Switch Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cruise control release switch electrical connector.
  2. With the electrical connector index notch at the 10 o'clock position, install the cruise control release switch to the retainer.

    Important:  Do NOT move or push the brake pedal.

  3. Slide the switch into the retainer until the plunger is fully depressed into the barrel.
    Fig 1: Installing Cruise Control Release Switch Electrical Connector
    G01517977Courtesy of GENERAL MOTORS CORP.
  4. Rotate the cruise control release switch clockwise until the travel stop has been reached (approximately 60 degrees). The electrical connector index notch should now be at the 12 o'clock position.
  5. Ensure that the cruise control system operates properly.
  6. Install the left side instrument panel insulator.

    Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT -- LEFT .

    Fig 2: Rotating Cruise Control Release Switch Clockwise
    G01517978Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals