Removal Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
- Remove the air cleaner outlet resonator stud.
- Remove the cruise control cable from the throttle pulley.
- Remove the cruise control cable from the engine bracket.
- Remove the accelerator control cable from the accelerator control bracket.
- Remove the accelerator control cable from the engine bracket.
- Remove the accelerator control cable slug from the throttle pulley.
- Remove the accelerator control cable bracket nuts.
- Remove the accelerator control cable bracket with the cables attached, from the throttle body.
- Position and secure the bracket and cables out of the way.
- Disconnect the following electrical connectors:
- Throttle position (TP) sensor (1)
- Idle air control (IAC) valve (2)
- Remove the throttle body studs.
- Remove the throttle body.
- Remove and discard the throttle body seal.
Fig 6: View Of TP Sensor, IAC Motor, ECT Sensor, Control Port Injector Module & Engine Harness Clip Bolt