LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2002 >> Aztek AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1256 (Wiper System & Washer System) >> Repair Instructions >> Washer Solvent Container Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Washer Pump Electrical Connector
    GM174219Courtesy of GENERAL MOTORS CORP.
  1. Position the washer solvent container to the vehicle.
  2. Connect the washer pump hose.
  3. Connect the washer pump electrical connector.
    4. Fig 2: Washer Solvent Container At Mounting Studs To Washer Pump
    GM829164Courtesy of GENERAL MOTORS CORP.
  4. Install the washer solvent container onto the mounting studs.
  5. Install the heater hose retention clamp onto the mounting stud.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the washer solvent container nuts.

    Tighten:  Tighten the nuts to 8 N.m (71 lb in).

    7. Fig 3: Washer Solvent Container Level Sensor Electrical Connector
    GM829207Courtesy of GENERAL MOTORS CORP.
  7. Connect the washer solvent container level sensor electrical connector.
  8. Fill the washer solvent container with washer solvent.
  9. Close the hood.
  10. Inspect the washer system for proper operation.
scientia non olet · About LEMON Manuals