LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2002 >> Aztek AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1284 (Rear Drive Axle) >> Repair Instructions >> Vehicle Speed Sensor (VSS) Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: VSS & Retaining Bolt
    GM71496Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the O-ring seal of the VSS with clean engine oil.
  2. Install the VSS into the hole on the axle case.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the VSS retaining bolt the differential.

    Tighten:  Tighten the vehicle speed sensor retaining bolt to 10 N.m (89 lb in).

    4. Fig 2: Vehicle Speed Sensor (VSS) Electrical Connector
    GM180649Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector to the sensor.
  5. Install the RH muffler assembly. Refer to Muffler Replacement - Right in Engine Exhaust.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals