Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Pulling Headliner Down Slightly & Slide Forward Reading Lamp

Courtesy of GENERAL MOTORS CORP.

Pull the headliner down slightly and slide the forward reading lamp into place.

Fig 2: Disconnecting/Connecting Electrical Connector To The Reading Lamp

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector to the reading lamp.
If the vehicle is equipped with OnStar®, install the microphone. Refer to Mobile Telephone Microphone Replacement .

Fig 3: Disconnecting/Connecting Electrical Connectors At Reading Lamp Cover/Sunroof Switch

Courtesy of GENERAL MOTORS CORP.

Position the forward reading lamp cover into the rear attaching hooks.
If the vehicle is equipped with a sunroof or with OnStar®, connect the electrical connectors.
Rotate the front reading lamp cover forward into the lamp assembly. Snap the cover into place.
If the vehicle is equipped with a sunroof, install the sunroof switch knob.

Fig 4: View Of Sunshade Anchors

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the sunshade retainers.
Tighten: Tighten the retainer fasteners to 2.5 N.m (22 lb in).
Position the sunshade outer brackets to the headliner.
Install the sunshades.
Tighten: Tighten the sunshade fasteners to 2.5 N.m (22 lb in).

IMPORTANT: If the vehicle is equipped with a side inflator module, position the inflator module tether rearward of the molding attaching clips.

Install the windshield upper garnish molding. Refer to Windshield Upper Garnish Molding Replacement .