Test Description
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
The number below refers to the step number on the diagnostic table.
- 3: If DTC B1001 is set as current, reprogram the module.
DTC B1001
| Step | Action | Yes | No |
|---|---|---|---|
| Connector End View Reference: Master Electrical Component List | |||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
Go to Step 3 | Go to Diagnostic Aids |
| 3 | Perform the programming or setup procedure for the module that set DTC B1001. Refer to Control Module References
for the proper procedure. Does DTC 1001 reset? |
Go to Step 4 | System OK |
| 4 |
IMPORTANT:
Perform the programming or setup procedure for the module. Replace the module that set DTC B1001. Refer to Control Module References
for the proper procedure.Did you complete the replacement? |
System OK | - |