Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Install the hub and bearing assembly (1) to the vehicle. Refer to WHEEL BEARING/HUB REPLACEMENT -- REAR .

Fig 1: Wheel Hub/Bearing Assembly
Courtesy of GENERAL MOTORS CORP.
Connect the electrical connector to the rear wheel speed sensor.

Fig 2: Rear Wheel Speed Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Install the wheel and tire assembly.
Lower the vehicle.
Turn the ignition switch to the ON position, with the engine off.
Perform the Diagnostic System Check - ABS