LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2002 >> Aztek AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 896 (Entertainment System) >> Repair Instructions >> Receiver Replacement - Digital Radio >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the coaxial cables.
  2. Connect the wire connector (1).
  3. Install the receiver and bracket assembly to the I/P.
    Fig 1: Installing Receiver And Bracket Assembly To The I/P
    GM854856Courtesy of GENERAL MOTORS CORP.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the 2 retaining screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

  5. Install the right side junction block to the I/P. Refer to Instrument Panel Electrical Center or Junction Block Replacement - Right in Wiring Systems.
  6. Close the I/P compartment door.
  7. Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .
scientia non olet · About LEMON Manuals