Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Brake Pedal Position Sensor

Courtesy of GENERAL MOTORS CORP.

Connect the brake pedal position sensor (2) electrical connector (1).

Fig 2: Aligning Brake Pedal Position Sensor With Actuation Arm

Courtesy of GENERAL MOTORS CORP.

Align the brake pedal position sensor (1) with the actuation arm (2) on the brake pedal and the brake pedal position sensor mounting bracket.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 3: Installing New 4 mm Bolt With LOCTITE™ To Brake Pedal Position Sensor

Courtesy of GENERAL MOTORS CORP.

Install a new 4 mm bolt (1), with LOCTITE™, to the brake pedal position sensor.
Tighten: Tighten the bolt to 9 N.m (80 lb in).
Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration Description and Operation .