Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of BPMV Bracket

Courtesy of GENERAL MOTORS CORP.

Install the BPMV assembly bracket to the vehicle.

NOTE: Refer to Fastener Notice .

Install the brake pressure modulator assembly bracket mounting bolts and nut.
Tighten: Tighten the bolts and nut to 10 N.m (89 lb in).

Fig 2: Removing/Installing Brake Modulator Assembly To The Bracket

Courtesy of GENERAL MOTORS CORP.

Install the brake modulator assembly to the bracket.
Tighten the 2 brake pressure modulator assembly insulator nuts.
Tighten: Tighten the nuts to 10 N.m (89 lb in).

Fig 3: Disconnecting/Connecting Electrical Connector From Electronic Brake Control Module (EBCM)

Courtesy of GENERAL MOTORS CORP.

Connect the EBCM electrical connector.

Fig 4: View Of Transmission Control Module

Courtesy of GENERAL MOTORS CORP.

Reposition the TCM, if equipped, to the mounting bracket.