LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2006 >> G6 GTP, 2D Convertible >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.9L - DTC P0010 To DTC P0300 >> DTC P0117 or P0118 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

IMPORTANT:
  • The cooling fans are commanded ON when certain DTCs are set.
  • If a short to voltage occurs, the ECT sensor may be damaged.
  1. Ignition OFF, disconnect the harness connector at the ECT sensor.
  2. Ignition OFF, test for less than 5 ohm of resistance between the low reference circuit terminal A and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the control module.
  3. Ignition ON, verify the scan tool ECT parameter is less than -38°C (-36°F).
    • If greater than the specified range, test the signal circuit terminal A for a short to ground. If the circuit tests normal, replace the control module.
  4. Install a 3A fused jumper wire between the signal circuit terminal A and the low reference circuit terminal B. Verify the scan tool ECT parameter is greater than 138°C (280°F).
    • If less than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the control module.
  5. If all circuits test normal, test or replace the ECT sensor.
scientia non olet · About LEMON Manuals