LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2006 >> GTO Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 6.0L - Introduction (2 Of 2) >> Repair Instructions >> Knock Sensor (KS) Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Knock Sensor, Engine Harness & Engine Block - Left Side
    GM1480894Courtesy of GENERAL MOTORS CORP.
  1. Reconnect the engine harness (3) and the KS (2) electrical connectors.
  2. Position the KS 2 on the engine block (4).
  3. Install the mounting bolt (1) for the KS 2.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Tighten the KS mounting bolt (1).

    Tighten:  Tighten the KS mounting bolt to 20 N.m (15 lb ft).

  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
scientia non olet · About LEMON Manuals