LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2006 >> Solstice Standard >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System & Starting System >> Repair Instructions >> Battery Negative Cable Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Bussed Electrical Center (BEC)
    GM1593202Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the negative battery cable. Route the cable through the engine wiring harness junction block bracket to battery, main side rail, and BEC.
  2. Install the battery cable clip bolt (3).

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  3. Install the negative battery cable clips (4) to the wheelhouse liner.
  4. Install the negative battery cable terminal from the BEC stud.
  5. Install the negative battery cable ground nut (1) at the BEC stud.

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

  6. Position the negative battery cable to the engine.
    7. Fig 2: Negative Battery Cable Ground Bolt
    GM1591855Courtesy of GENERAL MOTORS CORP.
  7. Install the negative battery cable ground bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    8. Fig 3: Negative Battery Cable Terminal
    GM1593197Courtesy of GENERAL MOTORS CORP.
  8. Install the negative battery cable terminal (3) to the stud.
  9. Install the negative battery cable ground nut (4) at the side rail stud.

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

  10. Connect the negative battery cable (1). Refer to Battery Negative Cable Disconnect/Connect Procedure .
scientia non olet · About LEMON Manuals