Test Description
The number below refers to the step number in the diagnostic table.
- 2: This test determines whether the engine can achieve the commanded RPM. If the engine does not reach the commanded RPM, the test determines whether the RPM is too high or too low.
DTC P0507
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Engine Controls Schematics Connector End View Reference: Powertrain Control Module (PCM) Connector End Views and Engine Controls Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
Go to Inducing Intermittent Fault Conditions | Go to Step 3 |
| 3 | Inspect for the following conditions:
Did you find and correct the condition? |
Go to Step 4 | - |
| 4 |
|
Go to Step 2 | Go to Step 5 |
| 5 |
IMPORTANT:
Be aware that repairing 1 individual condition may correct more than 1 DTC. Observe the Capture Info with a scan tool.Are there any DTCs that have not been diagnosed? |
Go to Diagnostic Trouble Code (DTC) List - Vehicle | System OK |