Power Distribution Module: Service and Repair

AC/DC POWER OUTLET CONTROL MODULE REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the negative battery cable.
2. Move the drivers seat to the full rearward position.
3. Remove the 2 bolts (1).
4. Fold the floor carpet to the inside.
5. Disconnect the electrical connector (2).
6. Remove the accessory AC/DC power control module (3) from the vehicle.

INSTALLATION PROCEDURE




1. Install the accessory AC/DC power control module (3) to the vehicle. Secure the module (3) with the 2 bolts (1).

Tighten the power control module bolts to 7.0 N.m (62 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

2. Fold the floor carpet to the inside.
3. Connect the electrical connector (2).
4. Move the drivers seat to it's original position.
5. Connect the negative battery cable.