Manifold Pressure/Vacuum Sensor: Service and Repair

MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the negative battery cable.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

2. Remove the manifold absolute pressure (MAP) sensor electrical connector.
3. Remove the MAP sensor bolt.
4. Remove the MAP sensor.

INSTALLATION PROCEDURE




1. Install the MAP sensor with the bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the MAP sensor bolt to 10 N.m (89 lb in).

2. Connect the MAP sensor electrical connector.
3. Connect the negative battery cable.