Steering Column: Inspection
- Ensure "U" joint has no play. Flex "U" joint and check for binding.
- Replace "U" joint if torque required to turn exceeds 4 INCH lbs. (.58 N.m). Check plastic washer for damage, and serration for wear.
- Check steering shaft length. On all except XT/XT6 and Justy, non-tilt column shaft length should be 20.32-20.40" (516.2-518.2 mm).
- On all except XT/XT6 and Justy, tilt column shaft length should be 11.67" (296.5 mm). On XT/XT6, shaft length should be 29.55-29.63" (750.1-752.1 mm). On Justy, shaft length should be 22.76-22.84" (578.2-580.2 mm).
- Check shaft runout. Runout for elliptical part should be less than 1.28" (32.5 mm). Runout for upper end of shaft should be less than .047" (1.2 mm).
- Runout for shaft collar (standard wheel) should be less than .024" (.60 mm). Replace steering shaft if not within specifications. Check bearings for damage. Replace any worn bearings.