Steering Wheel: Installation
WARNING: This page is about a different car, the 2001 Subaru Outback and 2001 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
- Align center of roll connector. See AIR BAG RESTRAINT SYSTEMS .
- Install in the reverse order of removal.
NOTE:
Align matching marks on steering wheel and steering column.
Tightening torque:
- 4.5 N.m (4.5 kgf-m, 32.5 ft-lb)
Column cover-to-steering wheel clearance:
- 2 - 4 mm (0.08 - 0.16 in)
WARNING:
Always refer to "Air Bag System" before performing airbag module service (if so equipped). See AIR BAG RESTRAINT SYSTEMS
.
CAUTION:
Insert roll connector guide pin into guide hole on lower end of surface of steering wheel to prevent damage. Draw out airbag system connector, horn connector and cruise control connectors from guide hole of steering wheel lower end.