SUBARU Select Monitor (OBD Mode)

On the «Main Menu» display screen, select the {Each System Check}.
On the «System Selection Menu» display screen, select the {Engine Control System}.
Click the [OK] button after the information of engine type has been displayed.
On the «Engine Diagnosis» display screen, select the {OBD System}.
On the «OBD Menu» display screen, select the {Clear Diagnostic Code?}.
When the "Clear Diagnostic Code?" is shown on the screen, click the [Yes] button.
When "Done" and "Turn ignition switch to OFF" is shown on the display screen, turn the ignition switch to OFF.

NOTE:

Initial diagnosis of electronic throttle control is performed after memory clearance. Therefore, start the engine 10 seconds or more after have turning the ignition switch to ON.
For detailed operation procedure, refer to the PC application help for Subaru Select Monitor.