Master Cylinder: Installation

WARNING: This page is about a different variant/trim than selected.

Install the master cylinder to the vehicle body, and connect the clutch pipe to the master cylinder.
NOTE: Check that the pipe is routed properly.

Tightening torque:

T1: 15 N.m (1.5 kgf-m, 11.1 ft-lb)

T2: 18 N.m (1.8 kgf-m, 13.3 ft-lb)

Fig 1: Identifying Clutch Pipe And Master Cylinder Bolts Tightening Torque
Courtesy of SUBARU OF AMERICA, INC.
Connect the push rod of the master cylinder to the clutch pedal, and install the clevis pin and snap pin.
NOTE: Apply grease to the clevis pin.

Fig 2: Identifying Push Rod, Clevis Pin And Snap Pin
Courtesy of SUBARU OF AMERICA, INC.
After bleeding air from the clutch system, ensure that the clutch operates properly. Refer to CLUTCH FLUID AIR BLEEDING .
Install the air intake chamber. (Non-turbo model) Refer to INSTALLATION , Air Intake Chamber.
Install the intercooler. (Turbo model) Refer to INSTALLATION , Intercooler.