Rear Height Sensor: Installation
WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
- Install the sensor assembly - headlight beam leveler.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the rear wheels.
Tightening torque:
120 N.m (12.2 kgf-m, 88.5 ft-lb)
- Lower the vehicle.
- Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
- Perform reinitialization of the auto headlight beam leveler system. <Ref. to
REINITIALIZATION , PROCEDURE, Auto Headlight Beam Leveler System.>NOTE: When replacing the rear vehicle height sensor with a new part, perform the initialization. <Ref. to INITIALIZATION , PROCEDURE, Auto Headlight Beam Leveler System.>