Section 17 (Body Control System (Diagnostics)): Customize: List
WARNING: This page is about a different car, the 2019 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- The setting items must match the actual vehicle equipment.
- Do not change settings except for setting below while setting the functions.
- Be sure not to change Factory initial setting except when installing a new body integrated unit.
| Data | Initial setting value | Customize setting | Remarks | ||
|---|---|---|---|---|---|
| Off delay time | 30s | OFF 10 Sec 20 Sec 30s |
Room light off delay time can be selected. | ||
| Auto Light Sensitivity Adjustment | Sensitive | Dull Normal Sensitive Very sensitive |
Sensitivity of the automatic lighting can be adjusted. | ||
| Remote Trunk Open/Power Rear Gate Open Function (ON/OFF) | ON | ON OFF |
ON: With key trunk/power rear gate long push function OFF: Without key trunk/power rear gate long push function |
||
| Power rear gate setting | - ((1)) | Yes No |
Yes: Power rear gate can be locked with the lock/unlock buttons. No: Power rear gate cannot be locked with the lock/unlock buttons. |
||
| Lane change signal setting | Yes | ON OFF |
Yes: One-touch blinker function operates. No: One-touch blinker function does not operate. |
||
| Rear wiper auto setting | - ((1)) | ON OFF |
Yes: Rear wiper operates in sync with the reverse shift. No: Rear wiper does not operate in sync with the reverse shift. |
||
| Driver's Door Unlock Setting | Selection | Selection ALL | Selection: When the touch sensor (unlock) on the driver's side is touched, only the driver's door is unlocked. When the touch sensor (unlock) on the passenger's side is touched, all doors are unlocked. ALL: When the touch sensor (unlock) on the driver's side is touched, all doors are unlocked. When the touch sensor (unlock) on the passenger's side is touched, all doors are unlocked. |
||
| Rear Gate Unlock Setting | Selection | Selection ALL | Selection: When the rear gate opener button is pressed, only the rear gate is unlocked. ALL: When the rear gate opener button is pressed, all doors are unlocked. |
||
| Daytime Running Light (DRL) Setting for North America | - ((1)) | High beam dimming system Dedicated light system | Set according to the daytime running light source type. | ||
| Wiper link Auto Light Setup | - ((1)) | ON OFF |
ON: Wiper interlock auto light function is activated. OFF: Wiper interlock auto light function is deactivated. |
||
| Steering Wheel | Left | Left Right |
Left: Left hand drive. Right: Right hand drive. |
||
| Vehicle Automatic Door Lock | Vehicle speed | OFF Vehicle speed Select lever P |
OFF: Vehicle automatic door lock function is not activated. Vehicle speed: Vehicle automatic door lock function is activated at or above a certain vehicle speed. Select lever P: Vehicle automatic door lock function is activated when the select lever is shifted from P to other than P. |
||
| Vehicle Automatic Door Unlock | Driver's door open | OFF Select lever P Power OFF Driver's door open |
OFF: Vehicle automatic door unlock function is not activated. Select lever P: Vehicle automatic door unlock function is activated when the select lever is shifted from P to other than P. Power OFF: Vehicle automatic door unlock function is activated when the IGN is turned from ON to OFF. Driver's door open: Vehicle automatic door unlock function is activated when the driver's door is operated from Close to Open. |
||
| P/W ECU Setting | - ((1)) | None Driver's seat Driver's seat, Passenger's seat 4 seats |
None: P/W does not operate. Driver's seat: P/W operates only on driver's seat. Driver's seat, Passenger's seat: P/W operates on driver's seat and on passenger's seat. 4 seats: P/W operates on all four seats. |
||
| Sunshade ECU Setting | - ((1)) | Yes No |
Yes: Equipped with sunshade. No: Not equipped with sunshade. |
||
| Ambient Light Setting | Yes | Yes No |
Yes: Equipped with ambient light. No: Not equipped with ambient light. |
||
| Ambient Light Setup | ON | ON OFF |
Ambient light is activated. Ambient light is not activated. |
||
| Head Lamp Low Beam Specification | - ((1)) | Halogen HID LED |
Set according to the headlight type. | ||
| Head Lamp High Beam Specification | - ((1)) | Halogen HID LED |
Set according to the headlight type. | ||
| High Beam Assist Current Setting | - ((1)) | ON OFF |
ON: Enable the HBA setting. OFF: Disable the HBA setting. |
||
| Rear defogger operation mode | 15 minutes (normal) | Normal Continuous |
Normal: Automatically stops in 15 minutes after the switch is turned to ON. Continuous: Repeats the cycle of 15-minute active condition and 2-minute inactive condition until the switch is turned to OFF. |
||
| Security Alarm Setup | ON | ON OFF |
ON: Warning function (hazard, horn) is activated. OFF: Warning function (hazard, horn) is deactivated. |
||
| Alarm delay setup | ON | ON OFF |
ON: The alarm monitor starts 30 seconds after the keyless lock operation. OFF: The alarm monitor starts immediately after the keyless lock operation. |
||
| Lockout prevention | ON | ON OFF |
ON: Key lockout prevention function is activated. (The function does not operate if safety knob is locked by hand.) OFF: Key lockout prevention function is deactivated. |
||
| Buzzer sounding setting | ON | ON OFF |
ON: Buzzer sounds when lock/unlock is selected by keyless entry system. OFF: Buzzer does not sound when lock/unlock is selected by keyless entry system. |
||
| Abnormal warning lamp flashing setting | ON | ON OFF |
ON: Buzzer sounds when lock/unlock is selected by keyless entry system. OFF: Buzzer does not sound when lock/unlock is selected by keyless entry system. |
||
| Door open warning | Yes | Yes No |
Yes: If a door stays half shut for 20 minutes, interior lighting linked with the door such as room light, map light, luggage room light, trunk room light and key ring illumination go off to prevent battery run-out. No: Room light, map light, luggage room light, trunk room light, key ring illumination and door warning light remain lit. |
||
| Dome Light Alarm Setting | OFF | ON OFF |
ON: Room light illumination is interlocked with the alarm. OFF: Room light illumination is not interlocked with the alarm. |
||
| Auto A/C Setting | - ((1)) | Yes No |
Yes: Equipped with auto A/C Control Module. No: Not equipped with auto A/C Control Module. |
||
| Wiper Deicer setting | - ((1)) | Yes No |
Yes: With wiper deicer function. No: Without the wiper deicer function. |
||
| Rain drop Detection Sensor Setting | - ((1)) | Yes No |
Yes: Equipped with rain drop detection sensor. No: Not equipped with rain drop detection sensor. |
||
| Seat Memory Setting | - ((1)) | Yes No |
Yes: Equipped with seat memory. No: Not equipped with seat memory. |
||
| Illumination Sensor Setting | - ((1)) | Yes No |
Yes: Equipped with illumination sensor. No: Not equipped with illumination sensor. |
||
| Factory initial setting | Market | Factory Market |
Factory: Factory mode. Market: Market mode. |
||
| Auto Wiper/INT Setting | AUTO | INT AUTO |
INT: Performs the front wiper INT drive. AUTO: Performs the front wiper AUTO drive. |
||
| EPB setting | Yes | Yes No |
Yes: Equipped with EPB. No: Not equipped with EPB. |
||
| Sunroof setting | - ((1)) | Yes No |
Yes: Activates the SRF function. No: Deactivates the SRF function. |
||
| Welcome Light Off Delay Time (Exiting) | 30 seconds | OFF 30 seconds 60 seconds 90 seconds |
Lighting time length of the welcome lighting (exiting) function can be set. | ||
| Welcome Light Off Delay Time (Approaching) | 30 seconds | OFF 30 seconds 60 seconds 90 seconds |
Lighting time length of the welcome lighting (approaching) function can be set. | ||
| Keyless Buzzer Volume | 5 | 1 - 7 | Buzzer volume can be set. | ||
| Auto Dimmer Cancel Setting | 3 | 0 (OFF) Least Less Normal More Most |
Auto dimmer cancel sensitivity can be set. | ||
|
|||||