Combination Switch (Light): Installation
WARNING: This page is about a different car, the 2019 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
- Do not allow harness and connectors to interfere or get tangled up with other parts.
- If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position.
- If the steering wheel and the sensor assembly VDC steering (steering roll connector) are removed, perform "VSC (VDC) Centering Mode" of the VDC. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM & H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE .
- Install the switch assembly combination turn dimmer.
- Using pliers, loosen the clamp.
- While the clamp is loose, insert the switch assembly combination turn dimmer so that its claw is engaged with the cutout of the column cover assembly.
- Install the clamp, and connect the connector.
NOTE: When replacing with a new part, engage the claw first, and then pull out the securing pin of the clamp. - Install the steering roll connector. Ref. to AIRBAG SYSTEM>ROLL CONNECTOR>INSTALLATION .
- Install the column cover assembly and the switch assembly combination wiper select. Ref. to WIPER AND WASHER SYSTEMS>COMBINATION SWITCH (WIPER)>INSTALLATION .
- Install the steering wheel. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>STEERING WHEEL>INSTALLATION .
- Install the driver's airbag module. Ref. to AIRBAG SYSTEM>DRIVER'S AIRBAG MODULE>INSTALLATION .
- Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .