Front Fog Light Assembly: Installation

WARNING: This page is about a different car, the 2019 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Install the mud guard front so that the front end of the mud guard (b), except for the clip fixing point, comes inside the bumper face (a).

Courtesy of SUBARU OF AMERICA, INC.

Install the fog light assembly front.
CAUTION: After connecting the connector, make sure that the bulb is locked securely.

Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
Install the mud guard front.
Lower the vehicle.
Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Adjust the fog light beam. Ref. to LIGHTING SYSTEM>FRONT FOG LIGHT ASSEMBLY>ADJUSTMENT>FOG LIGHT AIMING .