LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2019 >> Forester Base >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> CVT Transaxle (Diagnostics) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC P0966: Pressure Control Solenoid "B" Control Circuit Low >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P0966: Pressure Control Solenoid "B" Control Circuit Low: Notes

1. - 

DTC detecting condition: 

Immediately at fault recognition

Trouble symptom: 

Excessive shift shock

Wiring diagram: 

CVT control system Ref. to WIRING SYSTEM>CVT CONTROL SYSTEM .

G13228365Courtesy of SUBARU OF AMERICA, INC.
CAUTION:
  1. CHECK INPUT SIGNAL FOR TCM  .
    1. After driving with warm up condition, park the vehicle while depressing the brake pedal at "D" range.
    2. Using Subaru Select Monitor, read the data of [Commanded Forward & Reverse Linear Solenoid Current] and [Actual Forward & Reverse Linear Solenoid Current]. Ref. to TRANSMISSION (DIAGNOSTICS)>DATA MONITOR .

    Do [Commanded Forward & Reverse Linear Solenoid Current] and [Actual Forward & Reverse Linear Solenoid Current] almost match?

    Yes  : Check for poor contact of connector.

    No  : Go to  2 .

  2. CHECK HARNESS  .
    CAUTION: Start work after ATF cools down.
    1. Turn the ignition switch to OFF.
    2. Disconnect the TCM connector.
    3. Remove the transmission valve cover.
    4. Disconnect the control valve body connector.
    5. Measure the resistance between TCM connector and chassis ground.

      Connector & terminal 

      (T10) No. 16 - Chassis ground:

    Is the resistance 1 MΩ or more?

    Yes  : Go to  3 .

    No  : Repair the short circuit of harness.

  3. CHECK F&R SOLENOID  .
    1. Connect the connector for control valve body.
    2. Measure the resistance between TCM connector and transmission body.

      Connector & terminal 

      (T10) No. 16 - Transmission body:

    Is the resistance approximately 4 - 6 Ω? (When cold)

    Yes  : Check for poor contact of connector, and if no fault is found, replace the TCM. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION(TR580)>TRANSMISSION CONTROL MODULE (TCM) .

    No  : Go to  4 .

  4. CHECK HARNESS INSIDE TRANSMISSION  .

    Check for the harness pinch, damage.

    Is the check result OK?

    Yes  : Replace the control valve body. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION(TR580)>CONTROL VALVE BODY .

    No  : Replace the transmission harness.