Power Rear Gate Drive Unit: Installation
- Install the power rear gate drive unit.NOTE:
- The power rear gate stay is installed on the RH side. For operation procedures, refer to the procedures for power rear gate drive unit LH.
- Align the alignment mark on the body side with the arrow on the grommet side.
Tightening torque:
13 N.m (1.3 kgf-m, 9.6 ft-lb)
- Install the trim panel rear pillar UPR LH and the trim panel assembly apron LH. (When the power rear gate drive unit LH is removed) Ref. to EXTERIOR/INTERIOR TRIM>REAR QUARTER TRIM>INSTALLATION .
- Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .