Rear ABS Wheel Speed Sensor: Installation
CAUTION:
- Be careful not to damage the sensor.
- Do not apply excessive force to the sensor harness.
- Install the rear ABS wheel speed sensor.NOTE: Check the identification (mark) on the harness to make sure there is no warpage. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>General Description>SPECIFICATION .
Tightening torque:
Rear ABS wheel speed sensor: 7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the grommet, and connect the rear ABS wheel speed sensor connector.
- Install the trunk trim panel assembly - side (sedan model) or rear floor mat (OUTBACK model).
- Sedan model: Ref. to EXTERIOR/INTERIOR TRIM>TRUNK ROOM TRIM>INSTALLATION .
- OUTBACK model: Install the rear floor mat and the spacer - rear floor mat.
- Install the rear wheels.
Tightening torque:
Rear wheel: 120 N.m (12.2 kgf-m, 88.5 ft-lb)
- Lower the vehicle.
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .