Front Reduction Driven Gear: Disassembly

WARNING: This page is about a different variant/trim than selected.

Remove the front reduction driven shaft from the front reduction driven gear.
Remove the snap ring.

Courtesy of SUBARU OF AMERICA, INC.
Remove the retaining plate, drive plate, driven plate and dish plate.

Courtesy of SUBARU OF AMERICA, INC.
Remove the seal ring from front reduction driven shaft.

Courtesy of SUBARU OF AMERICA, INC.
Remove the ball bearing, while tapping the entire circumference around the ball bearing outer race a little at a time through the front reduction driven shaft hole using the round bar with diameter of 7 mm (0.28 in).

Courtesy of SUBARU OF AMERICA, INC.